250 Important Engineering Drawing MCQ Question and Answer | PDF Free Download
1.These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
- ALandscape maps
- BEngineering maps
- CTopographic maps
- DCadastral maps
2.This type of structural steel drawing shows all dimensions necessary for fabrication:
- AShop drawings
- BDesign drawings
- CWeldment drawings
- DApplication drawings
3.In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
- AOne inch or over
- BOne foot or over
- COne yard or over
- DOne rod or over
4.Some of the common terms used to describe technical drawing include:
- ADrafting
- BEngineering Graphics
- CEngineering Drawing
- DAll of the above
5.If designs require changes, they should be documented with:
- ADevelopment plans
- BProduct proposals
- CDocument reviews
- DEngineering change orders
6.Once a drawing is determined to be complete, the title block is used to document the change from:
- AA draft to a finished drawing
- BA finished to a working drawing
- CAn assembly to a finished drawing
- DA working drawing to a draft
7.EDM is the acronym for:
- AEnterprise data management
- BEngineering drawing management
- CEnterprise drawing manipulation
- DEngineering data manipulation
8.PDM is the acronym for:
- AProject drawing management
- BProduct drawing manipulation
- CProduct data management
- DProject data manipulation
9.Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
- ACircular
- BElliptical
- CLengthened
- DAngular
10.These plans, made by the steel fabricator, are assembly drawings for the steel structure:
- AWelding plans
- BAssembly plans
- CConstruction plans
- DErection plans
11.An Auto-CAD term that refers to a pre-drawn object which is stored in a drawing file and can be inserted into any other drawing file as needed is a
- ABlock
- BBrick
- CBalloon
- DNone of the above
12.A line drawn with a long section, short dash, and another long section is a
- AHidden feature
- BCenter of a circle
- CCenter axis of a hidden cylinder
- DCenter of a radius
13.Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion:
- ARight to left and top to bottom
- BRight to left and bottom to top
- CLeft to right and top to bottom
- DLeft to right and bottom to top
14.The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
- AWidth
- BHeight
- CLength
- DNone of the above
15.This is the term for the range of tightness or looseness resulting from the allowances and tolerances in mating parts:
- ALimits
- BFit
- CSpecifications
- DAllowance
16.In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
- ADetail
- BTitle block
- CParts list
- DIsometric
17.The edges of a cube in isometric projection make angles of this many degrees with each other:
- A30
- B60
- C90
- D120
18.These types of projectors converge at a vanishing point:
- APerspective
- BParallel
- COrthographic
- DOblique
19.Objects that are symmetric can be shown effectively using this type of section:
- AQuarter section
- BHalf section
- CFull section
- DSymmetric section
20.In isometric projection, all distances are approximately this percentage of their true size:
- A120 percent
- B80 percent
- C50 percent
- D20 percent