250 Important Engineering Drawing MCQ Question and Answer | PDF Free Download
1.This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
- ALug
- BBoss
- CChamfer
- DSpot face
2.When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
- APull the line from away from the starting point very carefully
- BInsure that Ortho is on
- CEnter 3 for the length of the line
- DRead the coordinate position on the Dynamic Readout
3.A full scale technical drawing will have a scale factor of
- A1 : 1
- B1 : 2
- C2 : 1
- D1 : 4
4.Using this as a communication and design review tool can help shorten the process and eliminate productivity barriers
- ADevelopment plans
- BPortable document files
- CThe Internet and e-mail
- DGantt charts
5.A round is a rounded surface on the ________ corner of a part.
- AInside
- BOutside
- CRadial
- DIsoplane
6.These gears transmit power between shafts whose axes intersect at any angle:
- AWorm gears
- BSpur gears
- CBevel gears
- DRacks
7.The ________ is a standard element of a section view in a technical drawing.
- ACutting Plane line
- BSection lines
- CMaterial hatch pattern
- DAll of the above
8.This is an angled surface used on cylinders to make them easier to handle:
- AFillet
- BTaper
- CChamfer
- DLug
9.Students can complete an associate's degree in drafting which normally takes about __________ years to complete.
- AOne
- BTwo
- CThree
- DFour
10.In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
- APrimary
- BSecondary
- CRevolved
- DPartial
11.Several of the tools used in traditional drafting include the following:
- AParallel straight edge
- B45 degree triangle
- CCircle template
- DAll of the above
12.The thread note for a typical bolt will include the
- AMajor diameter of the thread
- BMaterial
- CCenter line
- DOffset distance
13.The title block used on working drawings should include the
- ASheet number
- BLine type
- CLayer set
- DAll of the above
14.The typical parts list should include the
- APart number
- BManufacturing material
- CNumber of parts needed
- DAll of the above
15.The condition of a part when it contains the least amount of material is referred to as
- ASmallest
- BLMC
- CMMC
- DActual size
16.A back or backing weld is a type of:
- AGroove weld
- BResistance weld
- CArc and gas weld
- DUpset weld
17.A projection weld is a type of:
- AResistance weld
- BArc weld
- CGas weld
- DFillet weld
18.Before starting an isometric drawing in Auto-CAD the drafter needs to
- ASet the grid to isometric
- BSet the current layer to Def-points
- CTurn Object Snap off
- DTurn Ortho off
19.Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for_________.
- ACircle templates
- BTriangles
- CTechnical pens
- DLettering guides
20.When drawing a line using the relative coordinate system a line is created from
- A0, 0
- BThe ending point of the last line
- CThe beginning point of the last line
- DNone of the above